Geha Top Secret 260 S6 Operations Instructions download pdf (Page 9)

1003 9

Geha top secret 260

english

Paper jam

You have fed in too much paper.

NOTICE! Do not press rocker switch alter-

nately forwards/backwards (

 - 

).

Cutting unit could be damaged.

• Press rocker switch .

Pa per is pus hed out.

• Se pa ra te pa per stack.

• Press rocker switch



.

• Feed in pa per successively.

Shredded material container full

Red LED lights.

Paper shredder switches off

NOTICE!

Empty the cut material container,

immediately because if it is too full,

malfunctions can occur in the cutting

system.

• Switch equipment off. To do this tap

rocker switch



.

• Remove full shredded material bag

and insert new bag.

Door open

Red LED lights.

Document shredder switches off.

• Check whether front door is closed

properly.

For all other malfunctions, check whether the

motor was overloaded before contacting our

customer service. Let the shredder cool down

for approx. 15 – 20 mins. before using it again.







6 Troubleshooting

Switch off the shredder and pull out the mains

plug. When cleaning only use a soft cloth and

a mild soap-water solution. However, no water

must enter the equipment.

Check that the door switch is working properly:

Warning!

If the following procedure cannot be

performed, switch off the document

shredder, disconnect the mains plug

and contact customer service.

• Insert the mains plug and switch on the

shredder.

• Feed in a sheet of paper and open the front

door while the paper is being drawn in.

 The cutting unit must turn off immediately

and the “door open” indicator must light up.

• Close the door.

 The cutting unit must not yet restart.

• Pull the paper out of the feed opening. The

light barrier must be clear.

• Switch off the machine and then switch back

on.

 The cutting unit starts when paper is fed in.

Oil the cutting unit when

cutting performance

decreases or the device

becomes noisy, or every

time you empty the waste

container (Cross cut only):

• Spray special cutting apparatus oil through

the paper feed opening along the entire width

on to the cutting rollers.

• Run cutting system backwards (



) without

feeding paper.

Paper dust and particles are shaken off.

7 Cleaning and maintenance

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 50 51

Comments to this Manuals

No comments